POS-n-go Android POS Manual
The POS-n-go integration to the iCT 250 supports sale, refund and settlement transactions.
The payment terminal admin password is 1234567F.
Helcim client services can be reached at 1-877-643-5246.
The payment terminal can be run in stand-alone mode where transaction amounts are manually keyed, or in integrated mode where POS-n-go sends the amount.
To switch between integrated mode and stand-alone mode:
- Press the F1 soft key.
- If switching to stand-alone mode press F1 to confirm the change.
- The integrated mode displays Welcome/Bonjour on the idle screen.
- The stand-alone mode displays Elavon on the idle screen.
To download a terminal you must have your unique TMS identifier from Elavon support.
Telium Manager Download
To perform a key exchange:
- Press the # key.
- Press the 8 key for Host Management.
- Select 2 for EMV Public Key Load.
- Select 1 for EMV Public Key Load.
To configure payment terminal tips:
- Press the # key.
- Select 3 for Setup Menu.
- Select 4 for Trans Options.
- Select 5 for Tip Options.
- Select 1 for Tip and select Off or Std Tip Only.
To configure a static IP address on the payment terminal:
- Press the F key.
- Enter 1234567F for the Admin Password and press the green Enter key.
- Select 0 for Telium Manager.
- Select 3 for Initialization.
- Select 2 for Hardware.
- Select 2 for Ethernet Setup.
- Select 1 for Boot Protocol.
- Select 1 for Static Address.
- Select 2 for IP Address.
- Enter a static IP address and press the green Enter key.
- Select 3 for Subnet Mask.
- Enter a subnet mask and press the green Enter key.
- Select 4 for Gateway.
- Enter a gateway address and press the green Enter key.
- Select 5 for DNS 1.
- Enter a DNS 1 address and press the green Enter key.
- Select 6 for DNS 2.
- Enter a DNS 2 address and press the green Enter key.
- Select 10 to Save the changes and reboot the terminal.
- In the POS-n-go web portal, in the Terminals section, edit the associated terminal and set the Payment Terminal Processor to HLC and the Payment Terminal IP to the assigned static IP address. This setting will take effect after your next Download Settings.
To enable the integration on the payment terminal:
- Press the # key.
- Press the 9 key for Misc. Options.
- Select 1 for Semi-Integrated.
- Select 1 for Enable Semi-Integrated.
- Select On.
- Select 2 for Communication Type.
- Select 3 for Ethernet.
- Enter 10000 for the Terminal Port and press the green Enter key.
- Select 3 for Receipt Options.
- Select 2 for Terminal.
- Press the red Cancel key to back out to the main menu.
POS-n-go Basic Setup, Devices, Device Settings:
- Configure Payment Terminal Processor to Helcim.
- Configure Payment Terminal IP to 192.168.55.4.